The objective of the radon mitigation process is to expel the harmful gas and prevent it from getting into your home. According to the American cancer association, radon is carcinogenic to humans. It is the second leading cause of lung cancer, which is further amplified if the person being exposed is also a smoker.
Radon is mostly found underground, and therefore, the foundation of your home is most vulnerable. This is because it can slip through cracks and crevices and linger in the air, especially in non-ventilated rooms. The following are some of the elements your system ought to have for successful radon mitigation in Aurora.
Developing a successful Abatement System
Before you embark on the process of abatement, it is important to understand that no two homes are the same. The soil profile on your property could be different from that of your next-door neighbor. That is why it is advisable to schedule radon gas testing before designing the system.
The Foundation and Drainage
Get your home tested for radon before you start planning any major remodeling projects. It will be easier to manage the problem before you begin any renovations. Active Soil Depressurization is one of the affordable ways homeowners prefer to contain the gas.
The ASD process creates a vacuum so that the gas can be pulled out of the ground. It consists of a plastic pipe and a simple fan that pushes out radon into the air. For that to happen, the slab needs to be completely airtight.
The slab cannot have any cracks or inconsistencies, especially for vulnerable areas of your home, such as the basement. During renovations, ensure that there are no openings or crevices are introduced. Otherwise, there would be no sufficient negative pressure to pull out the gas.
Drain Tiles
You may also require dispensing of the moisture from underneath the structure. Hydrostatic forces can push radon gas up into your home. In such cases, you may install loops of perforated pipes around the building. The loops collect the water and drain it into a sump.
The biggest shortcoming with drain tiles is that they have to cover the entire perimeter of the building. It may not be possible to have them in some sections, which means those portions can still harbor the gas. The system ought to be installed by a professional who understands the codes for radon mitigation in Aurora.
Radon Detection and Testing
EPA standards stipulate that the discharge pipe should be ten feet above the ground. It ought to be over an attic or garage, preferably where there are no occupants. There should also be a detection system that is visible and can alert residents of the radon levels. There are temporary detectors that have a lifetime of between 48 hours and 30 days.
After installation, the radon gas removal system should be tested again no sooner than 24 hours, and no later than one month. Your radon mitigation professional will document the portions that have been treated and record the test results.
In Conclusion
There are many processes of radon mitigation you can apply to keep your home and family safe. Most installation methods are cost-effective and are worth the investment in time and resources. You ought to consult a professional with the skills and experience in radon abatement. If you are interested in more information, contact us today.
Recent Comments